Script update based on latest version from Tasmota
* add support for all esp32 variants
* add "-C" : Decode (demangle) low-level symbol names into user-level C++ names.
* Initial version of the PIR Staircase wipe up/down.
* Add pulldown reminder
* Workaround for missing D6 and D7 definitions on esp32dev
* Add pinouts for d1 mini (esp8266 and esp32) and NodeMCU (and Arduino)
* These IO pins on all these boards... NodeMCU and d1_mini esp32 supported. The others? Fingers crossed.
* Changed to not collide with led strip pins
* PIR on GPIO 15 and 16 on esp32 d1 mini
* Removed PIN number ifdefs, it is impossible to match all boards
* Settings in flash, info and API
* Update README.md
* Small doc changes
* Improved README
* Fixed error in reading configuration
* Add API documentation
* Documentation and code cleanup
* Add enable/disable to API settings
* Restore segment state when disabling plugin
* Add debounce
* Set segments in animation mode
* Set segments in animation mode
* Add support for HR04 sensors
* Add preliminary description for using an HR04 sensor
* Fixed typenumber and linked to datasheet
* Moved config away from defines to prevent user error
* Trigger Sensors through API
* Rename scripts folder so that it's name doesn't clash with the `pio` command (prevents platformIO in VSCode to work properly on Mac)
* Bugfix for detection problems
* Separated config from code
* Renamed Signal to Trigger pin
* Filename adjusted
* Clarifications and additions to README
* Fixed references to pio scripts
* Fixed API trigger bug
* Adjustments to README.md
* More efficient use of flash cycles, better naming
* Bugfix: bottom sensor was not read properly
* Renamed to Animated_Staircase
* Add note on ultrasonic sensor and esp32
* Better naming of defines
* Bugfix: Swipe down started with two steps.
* Removed upload port in nodemcuv2 section
Co-authored-by: Rolf <rolf@phobos.local>
Co-authored-by: Rolf <>
Frank