Update README.md
rodzic
157f254792
commit
5ba205031d
|
@ -50,6 +50,7 @@ NOTE: You do not need to compile arduino from source these files are in the ardu
|
|||
If done correctly you will see the arduino sketch compile successfully and output in the log showing the upload status.
|
||||
9. Once flash is done : restart printer
|
||||
<H3> If you have black bars and printer is not detected properly, it means you did not do the point 4 properly [check: FAQ#172](https://github.com/luc-github/Repetier-Firmware-0.92/issues/172)</H3> so go back to point 4.
|
||||
|
||||
10. After printer restarted <B>do not forget to send G-Code M502 then M500 </B>from repetier's Print Panel tab <B>or from the printer menu "Settings/Load Fail-Safe"</B> and accept to save the new eeprom settings.
|
||||
11. When update is complete <B>you must calibrate your bed height!</B>Use manual bed leveling in menu
|
||||
12. Next you can calibrate your filament as usual, and second extruder offset if you have.
|
||||
|
|
Ładowanie…
Reference in New Issue