Update README.md
rodzic
028565d55f
commit
0e0bbf91f9
|
@ -41,6 +41,7 @@ The previous version (based on repetier v0.91) can be found [here](https://githu
|
|||
Note : points 1 and 2 are only needed to wipe the stock fw or a corrupted fw, for update they are not necessary.
|
||||
Note 2: remove the jumper before flashing if still there
|
||||
3. Use an arduino IDE supporting arduino DUE, [1.8.0](https://www.arduino.cc/en/Main/Software) with Due 1.6.8 module from board manager [FAQ#166](https://github.com/luc-github/Repetier-Firmware-0.92/issues/166).
|
||||
<H3 style="color:red">Do not use 1.5.8 it is not supported and will give compilation [error: FAQ#201](https://github.com/luc-github/Repetier-Firmware-0.92/issues/201)</H3>
|
||||
4. Update variants.cpp arduino file with the one present in src\ArduinoDUE\AdditionalArduinoFile according your IDE version
|
||||
NOTE: You do not need to compile arduino from source these files are in the arduino directory structure [FAQ#114](https://github.com/luc-github/Repetier-Firmware-0.92/issues/114).
|
||||
5. Open the project file named repetier.ino located in src\ArduinoDUE\Repetier directory in the arduino IDE.
|
||||
|
@ -49,6 +50,7 @@ NOTE: You do not need to compile arduino from source these files are in the ardu
|
|||
8. Press the usual arduino compile and upload button.
|
||||
If done correctly you will see the arduino sketch compile successfully and output in the log showing the upload status.
|
||||
9. Once flash is done : restart printer
|
||||
<H3> If you have black bars and printer is not detected properly, it means you did not do the point 4 properly [check: FAQ#171](https://github.com/luc-github/Repetier-Firmware-0.92/issues/201)</H3> so go back to point 4.
|
||||
10. After printer restarted <B>do not forget to send G-Code M502 then M500 </B>from repetier's Print Panel tab <B>or from the printer menu "Settings/Load Fail-Safe"</B> and accept to save the new eeprom settings.
|
||||
11. When update is complete <B>you must calibrate your bed height!</B>Use manual bed leveling in menu
|
||||
12. Next you can calibrate your filament as usual, and second extruder offset if you have.
|
||||
|
|
Ładowanie…
Reference in New Issue