This fw is based on repetier fw and modified to work with DaVinci 1.0, 2.0 single fan and 2.0.
It works with host software like [repetier host](http://repetier.com), or as stand alone if you use a WIFI SD Card.
You can see more on [Voltivo forum](http://voltivo.com/forum/davinci-firmware).
Current firmware is based on version of modified [repetier FW](https://github.com/repetier/Repetier-Firmware) 0.92 : [bgm370 Da Vinci 1.0 FW](https://github.com/bgm370/Repetier-Firmware)
Sources are [here](https://github.com/luc-github/Repetier-Firmware-0.92)
The previous version (based on repetier v0.91) can be found [here](https://github.com/luc-github/Repetier-Firmware)
It gets rid off Da Vinci software and filament restrictions: it allows to use clear ABS because it allows to disable sensors, as well as others brand name filaments because it does not use cartridge chip, it allows any slicer or third-party host software usage in normal way.
##Current Status
#Alpha 1 - not tested - ready for testing
***
##Installation
Use arduino IDE supporting arduino DUE, [version 1.5.8+](http://arduino.cc/en/Main/Software#toc3)
Update arduino sources files (variants.cpp and USBcore.cpp) with the ones prensent in src\ArduinoDUE\AdditionalArduinoFiles\1.5.8
The project file is the repetier.ino located in src\ArduinoDUE\Repetier directory.
For upgrade from stock FW and revert to, please check DaVinci forum.
Do not forget to modify the configuration.h to match the targeted Da Vinci: 1.0, 2.0 SF or 2.0.
for basic installation just change :
'#define DAVINCI 1 // "1" For DAVINCI 1.0, "2" For DAVINCI 2.0 with 1 FAN, "3" For DAVINCI 2.0 with 2 FANS</code>'
1 for DaVinci 1.0 (1Fan, 1 Extruder)
2 for DaVinci 2.0 SF (1Fan, 2 Extruders)
3 for DaVinci 2.0 (2Fans, 2 Extruders)
For some board having slow response time heatbed sensor that generated a defect temperature :
Set WARMUP_BED_ON_INIT to 1, it will preheat bed if it is necessary to increase sensor response time when starting printer if defect is detected, if it is real sensor issue - it will stop after 10 seconds and generate temperature defect error.
To repurpose the main Extruder cooling fan to be controlled VIA M106/M107:
Set REPURPOSE_FAN_TO_COOL_EXTRUSIONS to 1, do not for get to add a fan with power source to cool extruder permanently if you use this option.
Once flash is done <B>do not forget to use M502 then M500 </B>from repetier <B>or got select printer menu "Settings/Load Fail-Safe"</B> and accept to save in eeprom to have correct eeprom settings.