/*
   RadioLib RF69 Transmit with AES Example

   This example transmits packets using RF69 FSK radio module.
   Packets are encrypted using hardware AES.
   NOTE: When using address filtering, the address byte is NOT encrypted!

   For default module settings, see the wiki page
   https://github.com/jgromes/RadioLib/wiki/Default-configuration#rf69sx1231

   For full API reference, see the GitHub Pages
   https://jgromes.github.io/RadioLib/
*/

// include the library
#include <RadioLib.h>

// RF69 has the following connections:
// CS pin:    10
// DIO0 pin:  2
// RESET pin: 3
RF69 radio = new Module(10, 2, 3);

// or using RadioShield
// https://github.com/jgromes/RadioShield
//RF69 radio = RadioShield.ModuleA;

void setup() {
  Serial.begin(9600);

  // initialize RF69 with default settings
  Serial.print(F("[RF69] Initializing ... "));
  int state = radio.begin();
  if (state == RADIOLIB_ERR_NONE) {
    Serial.println(F("success!"));
  } else {
    Serial.print(F("failed, code "));
    Serial.println(state);
    while (true) { delay(10); }
  }

  // set AES key to encrypt the packet
  // NOTE: the key must be exactly 16 bytes long!
  uint8_t key[] = {0x00, 0x01, 0x02, 0x03, 0x04, 0x05, 0x06, 0x07,
                   0x08, 0x09, 0x0A, 0x0B, 0x0C, 0x0D, 0x0E, 0x0F};
  radio.setAESKey(key);

  // enable AES encryption
  radio.enableAES();

  // AES encryption can also be disabled
  /*
    radio.disableAES();
  */
}

void loop() {
  Serial.print(F("[RF69] Transmitting packet ... "));

  // you can transmit C-string or Arduino string up to 64 characters long
  int state = radio.transmit("Hello World!");

  // you can also transmit byte array up to 64 bytes long
  /*
    byte byteArr[] = {0x01, 0x23, 0x45, 0x67, 0x89, 0xAB, 0xCD, 0xEF};
    int state = radio.transmit(byteArr, 8);
  */

  if (state == RADIOLIB_ERR_NONE) {
    // the packet was successfully transmitted
    Serial.println(F("success!"));

  } else if (state == RADIOLIB_ERR_PACKET_TOO_LONG) {
    // the supplied packet was longer than 64 bytes
    Serial.println(F("too long!"));

  } else {
    // some other error occurred
    Serial.print(F("failed, code "));
    Serial.println(state);

  }

  // wait for a second before transmitting again
  delay(1000);
}