Updated config.h

src/config.h

@@ -21,8 +21,8 @@
 // Enable semihosting to receive debug logs during development
 // See the README for details on how to set up debugging and debug logs with GDB
 // NOTE: Semihosting has to be disabled when the radiosonde is not connected to an STM32 programmer dongle, otherwise the firmware will not run.
-#define SEMIHOSTING_ENABLE
-#define LOGGING_ENABLE
+//#define SEMIHOSTING_ENABLE
+//#define LOGGING_ENABLE
 
 /**
  * Global configuration
@@ -169,7 +169,7 @@
 // Use a frequency offset to place FSK tones slightly above the defined frequency for SSB reception
 #define RADIO_SI4032_TX_FREQUENCY_HORUS_V1  432501000
 #define RADIO_SI4032_TX_FREQUENCY_HORUS_V2  432501000
-#define RADIO_SI4032_TX_FREQUENCY_CATS      430450000
+#define RADIO_SI4032_TX_FREQUENCY_CATS      430500000
 
 /**
  * DFM-17 only: Built-in Si4063 radio chip transmission configuration
@@ -185,13 +185,13 @@
 #define RADIO_SI4063_TX_CW_COUNT 1
 #define RADIO_SI4063_TX_PIP false
 #define RADIO_SI4063_TX_PIP_COUNT 6
-#define RADIO_SI4063_TX_APRS true
+#define RADIO_SI4063_TX_APRS false
 #define RADIO_SI4063_TX_APRS_COUNT 2
 #define RADIO_SI4063_TX_HORUS_V1 false
 #define RADIO_SI4063_TX_HORUS_V1_COUNT 1
 #define RADIO_SI4063_TX_HORUS_V2 true
-#define RADIO_SI4063_TX_HORUS_V2_COUNT 6
-#define RADIO_SI4063_TX_CATS false
+#define RADIO_SI4063_TX_HORUS_V2_COUNT 1
+#define RADIO_SI4063_TX_CATS true
 #define RADIO_SI4063_TX_CATS_COUNT 1
 
 // Continuous transmit mode can be enabled for *either* Horus V1 or V2, but not both. This disables all other transmission modes.