OpenBuilds CONTROL

	X WORK 0.000	Goto X0 (Work Coord) (G0 X0) Goto X0 (Machine Coord) (G53 G0 X0)
	Y WORK 0.000	Goto Y0 (Work Coord) (G0 Y0) Goto Y0 (Machine Coord) (G53 G0 Y0)
	Z WORK 0.000	Goto Z0 (Work Coord) (G0 Z0) Goto Z0 (Machine Coord) (G53 G0 Z0) Probe Z0 Wizard
	GOTO X0Y0Z0 (Work Coord) (G0 Z5, G0 X0 Y0, G0 Z0) (Retract Z to Work Coord Z5) GOTO X0Y0Z0 (Work Coord) (G53 G0 Z0, G0 X0 Y0, G0 Z0) (Retract Z to Machine Coord Z0)	Go to Pre-Defined Position (G28) Set Pre-Defined Position (G28.1) Go to Pre-Defined Position (G30) Set Pre-Defined Position (G30.1)

Inputs / Endstops

PIN	Status
X-Limit	NOCOMM
Y-Limit	NOCOMM
Z-Limit	NOCOMM
Probe	NOCOMM
Door Sensor	NOCOMM
Buttons	NOCOMM NOCOMM NOCOMM

Communications

Value	Status
Installed Version	NOCOMM
Backend Queue Blocked	NOCOMM
Connection Status	NOCOMM
Connected To	NOCOMM
Serial Queue	NOCOMM
Websocket Status	NOCOMM
Installed Firmware Version	NOCOMM

Flashing tool

You can use this section to flash Grbl onto a compatible controller
Careful, use with care, or when instructed by Support

Controller
Port
Firmware

Changelog

Not Connected

Job Queue: 0

Update Ready

Version 1.0.100 update ready to be installed!
Note that proceeding will:

Stops any running jobs
Shuts down this instance of OpenBuilds CONTROL
Launches the installer for the new version

You may want to wait until your machine is idle before continuing

Jog Widget

You can use your mobile device as an handheld Jog interface. To get started, open a web-browser on your Mobile device and navigate to
http://0.0.0.0:3000/jog.html
or scan the QR Code below