Fixes after moving to target board

software/Firmware/Src/main.c

@@ -10,20 +10,21 @@
 #include "ApplicationBuilder.h"
 
 #define LED_GPIO_PORT  (GPIOD)
-#define LED_GPIO_PINS  ( GPIO_PIN_0)
+#define LED_GPIO_PINS  GPIO_PIN_3 | GPIO_PIN_2
+
 
 int main( void )
 {
-	// just to test if the firmware is alive
-	 GPIO_Init(LED_GPIO_PORT, LED_GPIO_PINS,  GPIO_MODE_OUT_OD_LOW_FAST);
-	 //GPIO_WriteHigh(LED_GPIO_PORT, LED_GPIO_PINS);
-	 GPIO_WriteLow(LED_GPIO_PORT, LED_GPIO_PINS);
+	 // just to test if the firmware is alive
+	 GPIO_Init(LED_GPIO_PORT, LED_GPIO_PINS,  GPIO_MODE_OUT_PP_LOW_SLOW);
+	 GPIO_WriteHigh(LED_GPIO_PORT, LED_GPIO_PINS);
 
-//	ApplicationBuilder_Init();
+
+	ApplicationBuilder_Init();
 
 	while(TRUE)
 	{
-		//ApplicationBuilder_Tick();
+		ApplicationBuilder_Tick();
 	}
 }
 

software/Firmware/makefile

@@ -17,8 +17,8 @@ MCU         = STM8S003
 COMPILER    = __SDCC__
 DEFINES     = -D$(COMPILER) -D$(MCU) -DUSE_STDPERIPH_DRIVER
 
-CFLAGS      = -mstm8 --std-c99 $(DEFINES)
-LDFLAGS     = $(addprefix -I ,$(INCLUDEDIR))
+CFLAGS      = -mstm8 --std-c99 $(DEFINES) 
+LDFLAGS     = $(addprefix -I ,$(INCLUDEDIR)) 
 
 BUILD_DIR   = Build
 
@@ -28,7 +28,7 @@ IHX         = $(BUILD_DIR)/$(TARGET).ihx
 ################### BUILD PROCESS ###################
 .PHONY: all build clean flash
 
-all: make_build_dir build
+all: make_build_dir build flash
 
 
 make_build_dir:
@@ -76,5 +76,5 @@ clean:
 	rm -rf $(BUILD_DIR)/*
 
 flash: $(IHX)
-	/opt/stm8flash -c stlink -p stm8s103f3 -w $<
+	/opt/stm8flash -c stlink -p stm8s003f3 -w $<