kopia lustrzana https://github.com/Hamlib/Hamlib
974e619dd2
According to iwyu, to avoid unecessary rebuilds and to reduce the chances of breakages of the build if includes are rearranged, the code that uses serial_open() and ser_close() should include serial.h while the code that uses read_block() write_block() and similar should include iofunc.h, code that uses all of them should include both files. Found with iwyu. |
||
|---|---|---|
| .. | ||
| Android.mk | ||
| Makefile.am | ||
| README.aor | ||
| README.ar5000 | ||
| README.ar7030 | ||
| aor.c | ||
| aor.h | ||
| ar2700.c | ||
| ar3000.c | ||
| ar3030.c | ||
| ar5000.c | ||
| ar7030.c | ||
| ar7030p.c | ||
| ar7030p.h | ||
| ar7030p_utils.c | ||
| ar8000.c | ||
| ar8200.c | ||
| ar8600.c | ||
| sr2200.c | ||
README.ar7030
hamlib-1.2.3 aor ar7030.c
2004.11.26
Parameteraenderung fuer USB-Serial
//.post_write_delay = 0, //Device: /dev/ttyS0
//.post_write_delay = 85, //Device: /dev/tts/USB0 < 85 sec 'timedout after 0 chars'
Befehle mit rigctl
# rigctl -m 503 -r /dev/ttyS0
# rigctl -m 503 -r /dev/tts/USB0
Rig command: F Frequency: 0 .. 32016718 Hz
Rig command: f
Rig command: \get_freq
Rig command: M Mode: FM, AMS, AM, USB, LSB, CW, RTTY
Passband: 1 - 6
Rig command: m Passband: 800, 2100, 3700, 5200, 9500, XXXX (Value from RX) Hz
Rig command: L
Level: AF Value: 0.0 - 1.0
Level: RF Value: 0.1, 0.0 -0.1, -0.2, -0.3, -0.4 > +10, 0 ,-10 , -20, -30, -40 dB
Level: SQL Value: 0.0 - 1.0
Level: AGC Value: 0 > OFF, 2 > FAST, 3 > SLOW, 5 > MEDIUM
Level: CWPITCH Value: -4248 .. 0 .. 4215 Hz
Rig command: l
Level: AF
Level: RF
Level: SQL
Level: AGC
Level: CWPITCH
Level: RAWSTR
Level: STRENGTH Value: -121dBm ... -23dBm > S1 ... S9 + 50 dB
Rig command: \set_powerstat Status: 0 > Power off, 1 > Power on
Rig command: \get_powerstat
Rig command: \reset Reset: 1 > Software reset
Rig command: Quit Q q
Rig command: Quit Q Q
Rig command: 1 Caps dump for model 503
Friedrich Melchert (DC9RP)