/*
 *  Hamlib Racal backend - RA6790 description
 *  Copyright (c) 2004 by Stephane Fillod
 *
 *
 *   This library is free software; you can redistribute it and/or
 *   modify it under the terms of the GNU Lesser General Public
 *   License as published by the Free Software Foundation; either
 *   version 2.1 of the License, or (at your option) any later version.
 *
 *   This library is distributed in the hope that it will be useful,
 *   but WITHOUT ANY WARRANTY; without even the implied warranty of
 *   MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the GNU
 *   Lesser General Public License for more details.
 *
 *   You should have received a copy of the GNU Lesser General Public
 *   License along with this library; if not, write to the Free Software
 *   Foundation, Inc., 51 Franklin Street, Fifth Floor, Boston, MA  02110-1301  USA
 *
 */

#ifdef HAVE_CONFIG_H
#include "config.h"
#endif

#include <stdlib.h>

#include <hamlib/rig.h>
#include "idx_builtin.h"
#include "racal.h"


/* FIXME: ISB */
#define RA6790_MODES (RIG_MODE_AM|RIG_MODE_CW|RIG_MODE_SSB|RIG_MODE_AMS|RIG_MODE_FM)

#define RA6790_FUNC (RIG_FUNC_NONE)

#define RA6790_LEVEL_ALL (RIG_LEVEL_RF|RIG_LEVEL_AGC|RIG_LEVEL_IF)

#define RA6790_PARM_ALL (RIG_PARM_NONE)

#define RA6790_VFO (RIG_VFO_A)

/*
 * ra6790 rig capabilities.
 *
 * Required A6A1 serial asynchronous interface
 *
 */
const struct rig_caps ra6790_caps = {
.rig_model =  RIG_MODEL_RA6790,
.model_name = "RA6790/GM",
.mfg_name =  "Racal",
.version =  "0.1",
.copyright =  "LGPL",
.status =  RIG_STATUS_UNTESTED,
.rig_type =  RIG_TYPE_RECEIVER,
.ptt_type =  RIG_PTT_NONE,
.dcd_type =  RIG_DCD_NONE,
.port_type =  RIG_PORT_SERIAL,
.serial_rate_min =  300,
.serial_rate_max =  9600,
.serial_data_bits =  7,
.serial_stop_bits =  2,
.serial_parity =  RIG_PARITY_EVEN,
.serial_handshake =  RIG_HANDSHAKE_NONE,
.write_delay =  0,
.post_write_delay =  10,
.timeout =  2000,
.retry =  3,

.has_get_func =  RA6790_FUNC,
.has_set_func =  RA6790_FUNC,
.has_get_level =  RA6790_LEVEL_ALL,
.has_set_level =  RIG_LEVEL_SET(RA6790_LEVEL_ALL),
.has_get_parm =  RA6790_PARM_ALL,
.has_set_parm =  RIG_PARM_SET(RA6790_PARM_ALL),
.vfo_ops =  RIG_OP_NONE,
.preamp =   { RIG_DBLST_END },
.attenuator =   { RIG_DBLST_END },
.max_rit =  Hz(0),
.max_xit =  Hz(0),
.max_ifshift =  kHz(8),
.targetable_vfo =  0,
.transceive =  RIG_TRN_OFF,
.bank_qty =   0,
.chan_desc_sz =  0,

.chan_list =  { RIG_CHAN_END, },

.rx_range_list1 =  {
	{kHz(500),MHz(30)-1,RA6790_MODES,-1,-1,RA6790_VFO},
	RIG_FRNG_END,
  },
.tx_range_list1 =  { RIG_FRNG_END, },
.rx_range_list2 =  {
	{kHz(500),MHz(30)-1,RA6790_MODES,-1,-1,RA6790_VFO},
	RIG_FRNG_END,
  },
.tx_range_list2 =  { RIG_FRNG_END, },
.tuning_steps =  {
	 {RA6790_MODES,1},
	 RIG_TS_END,
	},
        /* mode/filter list, remember: order matters! */
.filters =  {
		/* at -3dB */
		{RIG_MODE_SSB, kHz(2.55)},		/* BW2 */
		{RA6790_MODES, Hz(300)},	/* BW1 */
		{RA6790_MODES, kHz(1)},		/* BW2 */
		{RA6790_MODES, kHz(3.2)},	/* BW3 */
		{RA6790_MODES, kHz(6)},		/* BW4 */
		{RA6790_MODES, kHz(20)},	/* BW5 */
		{RA6790_MODES, 0},	/* accept any BW */
		RIG_FLT_END,
	},

.cfgparams = racal_cfg_params,

.rig_init =  racal_init,
.rig_cleanup =  racal_cleanup,
.rig_open =  racal_open,
.rig_close =  racal_close,
.set_conf =  racal_set_conf,
.get_conf =  racal_get_conf,

.set_freq =  racal_set_freq,
.get_freq =  racal_get_freq,
.set_mode =  racal_set_mode,
.get_mode =  racal_get_mode,
.set_level =  racal_set_level,
.get_level =  racal_get_level,

.reset = racal_reset,
.get_info = racal_get_info,

};

/*
 * Function definitions below
 */