# main.py -- put your code here!

# from seriffont import *
#from sysfont import *
# from terminalfont import *
import gc

print(gc.mem_free())

def reboot(  ) : pyb.hard_reset()
#pyt = 0
#if pyt :
#  from ST7735 import makeg
#  t = makeg()
#else:
#  t = pyb.TFT("x", "X1", "X2")
#  t.initg()
#
#t.fill(0)
#
#print(gc.mem_free())

# import TFT
# TFT.run(t)

# Display animated circle on TFT -------------------------

#from bombs import bomber
#t.rotation(2)
#b = bomber(t)
#b.run()

# Accelerometer display ----------------------------------

# import Balance
# Balance.main()

# Carpenter level display using accelerometer ------------

# from level import Level
# l = Level(t)
# l.run()

# PIR motion sensor --------------------------------------

# import motion
# m = motion.motion(t)
# # m.run()

# Cat Treat Thrower --------------------------------------

# import TreatThrower
# tt = TreatThrower.TreatThrower(m)
# tt.run()

# L2082 Motor control ------------------------------------

# from L298N import Motor
# m1 = Motor('Y1', 'Y2', ('Y3', 4))
# m2 = Motor('Y5', 'Y6', ('Y4', 4))

# IR or SR04 distance display ----------------------------

# from IRDistance import IRDistance
# r = IRDistance("X12")

# from SR04Distance import SR04Distance
# r = SR04Distance("Y2", "Y1")

# t.rotation(2)
# from DistanceDisplay import Display
# d = Display(t, r)
# d.run()

# Bluetooth board ----------------------------------------

# from JYMCU import JYMCU

# u = JYMCU(6, 57600)
# u.write("Testing.")
# u.readline()
# u.setrepl()

# from pyb import ExtInt

# x = 0
# def cb(line):
#   global x
#   x += 1
#   print(x)

# f = ExtInt("Y2", ExtInt.IRQ_RISING, pyb.Pin.PULL_UP, cb)

# WIFI board ----------------------------------------

# from ESP8266 import WIFI

# v = WIFI(6)

# from pyb import Pin
# p = Pin("X11", Pin.IN, Pin.PULL_DOWN)
# def v(): return p.value()

# Accelerometer board ----------------------------------------

#from GY521 import Accel
#
print(gc.mem_free())
#
#a = Accel(1)
#def d(): return a.acceltemprot
#
#print(gc.mem_free())

#import gyreport
#
#print(gc.mem_free())
#
#m = gyreport.motion(1, t)
#
#print(gc.mem_free())
#
#m.run()
#
#print(gc.mem_free())

def do( ) :
  return pyb.MPU6050('x', 0)

#def prnt( dev, font ) :
#  dev.text((10, 10), "Hello!", 1, font, 1)
#  dev.text((10, 30), "Hi Again?", 1, font, 3)