0.72 Sends GPS updates when in Idle and Signal gen mode and when pausing in WSRP Beacon mode. Improved Serial port respons when pausing in WSPR Beacon mode,
On the Mini the GPS and the Si5351 is put to power save during long TX Pauses. Current draw is now arround 40 mA regardless if tranmitting or not.
0.69 Added support for hardware WSPR-TX Mini 1021, added funtion readVcc() that returs Arduino Voltage, added PowerSave funtions save current on the Mini
0.70 Added power saving for the Mini, GPS turned off if TX pause is longer than a minute.
0.71 Corrected 2m Frequency, not in use but nice to have correct. Enabled PLL power saving for the Mini if TX pause is longer than a minute. Current draw for mini is: 40mA waiting to TX, 60mA TX, 5mA during long TX pauses (More than a minute)
0.68 Added support for manual override relay control over the Serial API and Relay update messages. ([CSL] command and {LPI} status message, shortened Start LED Blink
0.57 Split Firmware in to two separate version for the WSPR-TX_ LP1 and LP4 products and changed the "Product_Model" from Factory EEPROM data to constant
Added factory EEPROM data that can contain Reference frequency data, product code, hardvare version and revision of the transmitter.
This EEPOM data will be set by the "Factory Config" PC program and read and used by the PC Configuration software
1 Improved serial port handling to avoid program crashes if serial port goes away, still not perfect but better than last version
2 Improved configuration data updates.
Harry